4
FUNCTIONAL
DESCRIPTION
13
5
4
6
7
8
9
11
2
3
12
1
1. Battery latch lever
2. Battery lock ring
3. Carry handle
4. Fuel gauge
5. Battery charging status / charger indicator
6. Arm button
7. AC outlets
8. Overload indicator
9. Overheat indicator
10. Grounding terminal
11. AC input
12. Fan
13. M12™/M18™charger screw mounts
10
EXTENSION CORDS
Grounded tools require a three wire extension
cord. Double insulated tools can use either a two
or three wire extension cord. As the distance from
the supply outlet increases, you must use a heavier
gauge extension cord. Using extension cords with
inadequately sized wire causes a serious drop in
voltage, resulting in loss of power and possible tool
damage. Refer to the table shown to determine the
required minimum wire size.
The smaller the gauge number of the wire, the greater
the capacity of the cord. For example, a 14 gauge
cord can carry a higher current than a 16 gauge cord.
When using more than one extension cord to make
up the total length, be sure each cord contains at
least the minimum wire size required. If you are using
one extension cord for more than one tool, add the
nameplate amperes and use the sum to determine
the required minimum wire size.
Guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure
it is marked with the suffix “W-A” (“W” in Canada)
to indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired
and in good electrical condition. Always replace a
damaged extension cord or have it repaired by a
qualified person before using it.
• Protect your extension cords from sharp objects,
excessive heat and damp or wet areas.
Recommended Minimum Wire Gauge
For Extension Cords*
Nameplate Amps
Extension Cord Length
25'
50'
75'
100'
150'
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 16.0
16.1 - 20.0
18
18
18
18
16
14
12
18
18
18
16
14
12
10
18
18
16
14
12
10
--
18
16
14
12
10
--
--
16
14
12
12
--
--
--
* Based on limiting the line voltage drop to five volts at 150%
of the rated amperes.
READ AND SAVE ALL INSTRUCTIONS
FOR FUTURE USE.
SPECIFICATIONS
Cat. No. .....................................................MXF002
Battery Type ........................................ MX FUEL™
Charger Type
....................................... MX FUEL™
Rated Input Voltage ................................. 120 V AC
Rated Input Amps ............................................3.9 A
Rated Output Voltage (Charger) ................72 V DC
Rated Output Amps (Charger) .................. 4.5 A DC
Rated Output (Receptacle)
Peak Watts
.............................................. 3600 W
Continuous Watts
.................................... 1800 W
Voltage........................................................ 120 V
Rated Frequency .......................................... 60 Hz
Recommended Ambient
Charging Temperature
....................40°F to 105°F
(5°C to 40°C)
