3-29
1
1
3
Useful Fu
n
ction
5
6
Other Useful Functions
Setting a COMMAND
Setting a PRIORITY
When this plotter and the host computer make different settings on a same item, this function is used to set about
which of the two must be given priority to
1
Select [COMMAND SETTING] of the set up menu.
(1)
Press the
key in LOCAL.
(2)
Press
to select [SET UP] and press the
key.
(3)
Press
to select [COMMAND SETTING].
(4)
Press the
key.
2
Press the jog key
or
to select [PRIORITY] .
3
Press the
key.
4
Press the jog key
or
, select the item to be
set.
5
Press the
key.
1
Press the jog key
or
to select Setting.
• Set values:
HOST:
This is to give priority to the setting of host computer.
PANEL:
This is to give priority to the setting of this plotter.
• If set other items, repeat the procedure from step 4 to 7.
6
Press the
key.
• Press
if you do not want to save the setting.
7
Press the
key several times to end the setting.
SP;
Pen selection command
VS;
Pen lowering speed setting command
ZA;
Pen lifting speed setting command
AS;
Acceleration setting command
FS;
、
ZF;
Pen pressure setting command
ZO;
Cutter blade compensation setting command
FUNCTION
< SE T UP >
RS - 2 3 2 C
[ ENT ]
< RS SE T T I NG>
BAUD RA T E : 9 6 0 0
< PR I OR I T Y >
ZO
: HOS T
< PR I OR I T Y >
ZO
: HOS T
< PR I OR I T Y >
ZO
: PANE L
< SE T UP >
S T ART MODE : REMOT E
Summary of Contents for CFL-605RT
