CHAPTER 2
BASIC OPERATION
2-33
Pause of Plot Out
Execute the following procedures to pause the plot out. Refer to the next page for discontinuation of the plot out.
1
Depress the key so as to display the
following display. While the display
is appeared, movement of the plotter
does not stop.
2
The pause mode is obtained, and
movement of the plotter stops.
• The tools conditions may be
changed (only parameter
change) during the pause
mode. The method is differed
from tool mode. Refer to the
applicable page, and change
the condition.
• Under automode : Chapter 3
"CHANGE OF THE TOOLS
CONDITIONS" Step 2 on in
(P.3-6)
• Under manual mode: this
chapter "Setting Method under
Manual Mode" Step 2 on in
(P.2-11)
3
Depress the
key again for
restart of the plot out.
TRANSMISSION OF DATA FROM COMPUTER
<-- [CLEAR] AUTO CUT-->
<-- PEN SET HALF CUT-->
Summary of Contents for cg-100AP
