CHAPTER 5
TROUBLE SHOOTING AND POSSIBLE REMEDY
5-13
DISPLAY OF ERROR MESSAGE
a. Cleanup the inner barrel of the me-
chanical pencil. (P.1-45)
b. Replace with a new mechanical pen-
cil.
The mechanical pencil on the dis-
played magazine No. did an abnor-
mal operation.
Error Message
Probable Cause
Corrective Measure
8 pens are attached in the magazine,
the pen on the carriage can't be re-
turned.
Remove a pen in the magazine.
The key inoperable unde the, pause
mode was pressed.
Carry out the data clear.
put the mode into offline, then start the
operation. (P.3-4)
No magazine is set on the Plotter.
Set the magazine loading the tools.
There is no tool in the set magazine.
Set the proper magazine from the attach-
ment. (P.2-22)
An improper GL command was es-
tablished.
Put the tools into the magazine, then set
on the plotter.
A command unacceptable for the
plotter was received.
Properly establish the GL command.
A noise conducts into the commu-
nication circuit.
Do not use unacceptable commands.
The rolled media was skewed.
Use the interface cable specified by this
MIMAKI.
The function was executed without
setting the media.
Properly set the rolled media. (P.2-25)
PENCIL ERROR #
*
CAN'T STORE PEN
C A N N O T E X E C U T I O N I N
P A U S E . D O [ C A N C E L ]
NO PEN MAGAZINE
MAGAZINE SET ERROR
NO PEN
INVALID CODE
PAPER SKEW ERROR
PAPER NOT LOADED
PAPER TOO SHORT
C T S T I M E O V E R E R R O R
The media length is 180mm and be-
low.
Set the media, then start the operation.
A magazine other than the attach-
ment was set.
The magazine is not securely set
Securely set the magazine. (P.2-22)
Set the media of which length is 181mm
and over.
Since the CTS line does not turn
ON, data receiving can not be car-
ried out.
Make sure that a CTS line is incorpo-
rated in the interface cable. (to be con-
tinued to the next page)
Summary of Contents for cg-100AP
