3-14
PLOTTING SCALE SETTING
The scale referred to herein is a function to reduce or enlarge the received data for the plot out. The origin is taken
as the basis for the reduction and enlargement. This setting returns to 100% (scale factor) whenever the power is
turned OFF. Refer to Chapter 6 "TABLE OF SCALES" (P.6-12) for the scale factor of the reduction and enlarge-
ment.
1
The third page of the menu will be
displayed under the offline mode.
2
Select [SCALE].
3
Change the [RATE].
-F1+
: To be 100%
-F3+
: To reduce down to 10%
-F4+
: To enlarge up to 1000%
4
Register the scale.
X
X
Y
X
Y
Y
Y
X
<--SCALE AUTO FEED-->
<--COMPEN DIST-CMP-->
-PAGE+
-F1+
INITIAL RATE : 100%
REDUCTION ENLARGE
END
<--SCALE AUTO FEED-->
<--COMPEN DIST-CMP-->
Origin: At [CENTER]
Enlarged to 200%
Origin: At [RH LOWER]
Reduced to 50%
Summary of Contents for cg-100AP
