4-4
1
Set the cutter
Refer to Chapter 2 "Preparation of
the Tools" (P.2-21).
2
Set the paper. The online mode will
b e s e l e c t e d .
Refer to Chapter 2 "PAPER SET-
TING" (P.2-25).
3
Select the offline mode.
Execute Chapter 3 "DATA CLEAR"
(P.3-4).
• When square cut is executed,
the paper is cut at the lower
right position.
When you want to change the
cutting position, execute
"MOVEMENT OF ORIGIN"
(P.3-12), and move the posi-
tion of origin.
4
Display the fifth page of the menu.
5
Select [SELF TEST], and the follow-
ing display will be appeared.
6
Select [SQR-CUT], and the following
display will be appeared and the cut
will be started.
7
The cut is ended and returned to the
first page of the menu.
SQUARE CUT
A square pattern is cut so as to verify the cutter tooling condition and set of the half cut. Set the cutter on the
magazine and set the paper for the verification.
1.5cm
-PAGE+
<--SELFTEST PRM-LIST-->
<--LINE : OFF DUMP-->
-F1+
PLOT # 1 PLOT # 2
SMPL-CUT SQR-CUT
<--CLEAR AUTO CUT-->
<--PEN SET HALF CUT-->
-F4+
SQUR) # X
XXXg XXXcm X. XG X. XX
Summary of Contents for cg-100AP
