CHAPTER 5
TROUBLE SHOOTING AND POSSIBLE REMEDY
5-3
Host computer transmit data, but the UNIT does not operate.
Plotting position is improper
Was the inner barrel of the me-
chanical pencils cleaned up?
Clean up (See page 1-45.)
Yes
No
INDICATIONS OF FAILURE
Is the interface cable connected?
(See page 1-19.)
Select the online mode. (See page
1-26.)
Is the interface cable connected?
Is the online mode selected?
Yes
No
No
Confirm the service life of the
mechanical pencils.
(See page 1-46.1-47)
Properly set the origin. (See page
3-10.)
Is the origin setting agreed with
CAD data?
No
Under mechanical pencils plotting, knocking happens fre-
quently
A cut (plot) is slipped off.
Yes
No
The media runs off from the pinch
roller.
The plot out has been achieved for
a long time, and the media stron
contact with the floor or the like.
Reduce the speed of the tools
conditions so as to moderate the
shock.
Refer to ---> P.3-6.
Correct the position of the pinch
roller so that the media would not
be come off from the pinch roller,
Properly set the media.
Refer to ---> P.2-25for roll type
P.2-29-for leaf type
Summary of Contents for cg-100AP
