3-66
Command Switching
• Changing the setting value will clear the data in the receiver buffer.
• With a large size of data, the [AUTO] mode may not function normally. In that case, change the setting
to MGL - Ic1 or MGL-IIc.
• Once the plotter receives data from the computer with [AUTO] selected, the display panel indicates the
recognized command and the plotter stars cutting. The display panel may continue indicating a
command name or display [ERR16 UTO I/F] if the command cannot be recognized automatically. In
such a case, change the command setting to MGL-I c1 or the MGL- IIc to perform normal cutting.
• The recognized command by [AUTO] will be effective until the data clear (
P.3-54) is executed or
sheet setting is performed again.
Function
name
Outline
Setting values
Jog Step
This is to set the moving amount of
carriage and sheet via the jog key.
0.1mm
(set in mm)
0.1mm movement per jog key operation
1.0mm
(set in mm)
1.0mm movement per jog key operation
1/16inch
(set in inch)
1/16inch movement per jog key operation
1 / 2 5 4 i n c h
(set in inch)
1/254inch movement per jog key operation
mm/inch
This is to select the unit with which
you want to display the length.
mm
This is to display in mm.
inch
This is to display in inch.
Feed
Offset
Regarding AUTO FEED, this is to
add the offset value to feed a little
bit longer.
0 to 100cm
Dummy
cutting
When this is set to “ON,” the blade
edge is made to turn to a specific
direction before starting cutting,
which allows dummy cutting.
ON
This is to perform dummy cutting every time
the tool and cutting conditions are changed.
OFF
This is not to perform dummy cutting.
Sheet
setting
This is to set the types of sheet
according to the sheet you use.
Standard
This is to be set when you use the regular
sheet.
Heavy
This is to be set when you use heavier sheet
than the regular one.
(But this reduces the cutting highest speed
down to 20cm/s.)
Compens
ated
pressure
offset
This is used to expand the value in
such a case as when the beginning
and end part of the cut are left cut.
0 to 7
Around 4g to around 28g
Over Cut
Make the media without uncut area.
OFF, 0.1 to
1.0 mm
Start
Mode
Set the mode after detecting the
sheet.
LCL
The mode switches to the standby condition
of the local mode after detecting the sheet.
REM
The mode automatically switches to the
remote mode after detecting the sheet.
Search
Mark
Set the automatic registration mark
search function performed after the
sheet is detected.
P.3-30
Summary of Contents for CG-60SR
