2-10
Setting the tool conditions
You must set the tool conditions adjusting to your use.
Kinds of the Tool Conditions
The kinds of the tool conditions include cutting, plotting and pouncing conditions.
See P.2-10 for the way of setting tool conditions.
Kinds
Description
Cutting Condition (CUT1
～
CUT5)
This is the tool conditions for using the cutter.
Plotting Condition (PEN)
This is the tool conditions for using a pen.
Pouncing Condition (PIN)
This is the tool conditions for using POUNCING.
Cutting Condition (HALF)
This is the tool conditions for performing the dotted cutting.
You must set the setting of the dotted cutting to ON in
advance (
P.3-59
)
• PIN and the HALF are not displayed unless the [POUNCING] and [HALF CUT] functions have
been set.
（
P.3-59
、
3-61
）
C U T 1
2 0
0 5 0
0 . 3 0
C U T 2
2 0
0 8 0
0 . 3 0
C U T 3
0 5
1 5 0
0 . 3 0
C U T 4
2 0
0 6 0
0 . 3 0
C U T 5
2 0
0 7 0
0 . 3 0
C U T 1
2 0
0 5 0
0 . 3 0
OFFSET
The distance from the center
of the cutter holder to the
cutter blade
PRESSURE
The pressure required
for cutting
SPEED
The speed of cutting
P E N
4 0
0 8 0
P E N
4 0
0 8 0
You need not to set OFFSET.
P I N
4 0
0 8 0
0 0 2 P
P I N
4 0
0 8 0
0 0 2 P
Pouncing interval value (P)
This is to set the interval of
pouncing.
H A L F
2 0
0 4 0
0 . 3 0
H A L F
2 0
0 4 0
0 . 3 0
OFFSET
Summary of Contents for CG-60SR
