27
Before taking a phenomenon as a trouble
Take appropriate remedies referring to the phenomena described below.
Length in data and cut length are different.
Cause 1 :
Sheet feed length will change depending on the
sheet thickness.
Remedy 1 :
Execute distance correction.
Slippage of sheet arises in cutting.
Cause 1
:
The pinch rollers and grid rollers fail to securely
retain the sheet in position.
Remedy 1 :
Check the position of the pinch rollers and grid
roller and adjust them so that they securely retain
the sheet in position.--->P.12,13
Cause 2
:
The roller sheet is not wound with properly
tensed and is slack. The sheet meanders or
becomes aslant at the time of the sheet feed.
Remedy 2 :
Remove a slack of the roll sheet and straighten
the right and left end faces of the roll when
loading the roll sheet on the device. Then,
execute the sheet feed.--->P.12
Cause 3
:
The sheet has bent to come off the mount to have
air bubbles between them.
Remedy 3 :
If the sheet is to be cut longer, take care not to
allow the sheet to bend while it is fed or cut to
avoid an extra load to the sheet.
Cause4
:
The sheet comes in contact with the floor
surface. (The front end of the sheet is cut aslant.)
Remedy 4 :
Decrease the cutting speed (SPEED) to reduce
the load to the sheet when it contacts the floor
surface.--->P.14,15
The device drags the tool during running.
Cause 1
:
The sheet is warped.
Remedy 1 :
Load the sheet on the device taking care not to
warp it.
Cause 2
:
The lifting/lowering of the tool is faulty.
Remedy 2 :
Turn the power off and lift/lower the tool holder
by hand.
If the tool holder does not go up but remains in
the lower position, call your distributor on the
phone for maintenance.
The device cannot detect a sheet. [** NO SHEET **]
Cause 1
:
A transparent sheet or a sheet of which wrong
side is black is used.
Remedy 1 :
Set the sheet sensor function to OFF.
--->P.19
The device performs cutting to produce broken lines.
Cause 1
:
Screw in the tool holder has loosened.
Remedy 1 :
Tighten the screw.--->P.10
Cause 2
:
The blade of the cutter protrudes excessively.
Remedy 2 :
Adjust the protruding amount of the blade
adequately.--->P.30
Cause 3
:
The blade is chipped or has worn out.
Remedy 3 :
Replace the blade with a new one.
--->P.30
A communication error arises in prior to receiving
data.
Cause 1
:
The power to the device and that to the host
computer have been turned on in wrong order.
Remedy 1 :
Turn on the power to the host computer first.
Then, turn on the power to the device.
--->P.7
The device does not operate even if the host
computer sends data to the device.
Cause 1
:
The plotter name specified on the host computer
is wrong.
Remedy 1 :
Check up the plotter name specified on the host
computer.
Cause 2
:
The interface cable is not securely connected to
the device and/or the host computer.
Remedy 2 :
Securely connect the interface cable.
--->P.7
An error arises on the device when the host
computer sends data to the device.
Cause 1
:
Communication conditions have not been
properly established.
Remedy 1 :
Check up the communication conditions.
--->P.8
