– 3.23 –
* When setting the width between the pinch roller 1 and the pinch roller 3 as
the maximum width, the available automatic sheet cut range is as follows.
40mm from the inside of the pinch roller 1
80mm form the inside of the pinch roller 3
Setting value
Number of cutting sheet :1 to 999,999 sheets
Cut length
:1 to 10,000 mm
Front cut off
:0 to 30 mm
1
Make sure that the plotter is in local mode, and
then press the [FUNCTION] key.
2
Press the [ENTER/HOLD] key.
3
By pressing the jog key [ ] or [ ], set the
number of times cutting is to be performed.
4
Press the [ENTER/HOLD] key.
5
Set the cut length (mm) by pressing the jog key
[ ] or [ ].
6
Press the [ENTER/HOLD] key.
7
Set the front cut off length by pressing the jog
key [ ] or [ ].
8
Press the [ENTER/HOLD] key after completing
the settings.
The number of cut sheets is displayed while cutting operation
is being performed.
SHEET CUT <ENT>
COUNT = 100
COUNT = 1
SPACE = 1000 mm
SPACE = 000 mm
FRONT CUToff = 10
FRONT CUToff = 0
CN : 10 / 999999
FUNCTION
Summary of Contents for CG-FX SERIES
