– 3.46 –
Specify the sheet type [SHEET SET]
In the case where a heavy sheet or wide sheet is to be used, the sheet setting is performed using the
sheet setting function to avoid displacement of the sheet.
In the case where the [SHEET SET] is set to [HEAVY], the maximum speed that can be specified
will be 20 cm/s and the acceleration will be a half of the normal value.
Setting value
NORMAL · HEAVY
* Do not cut (plot) a heavier or wider sheet at high speed, or the sheet may
displace.
Too heavy or wide sheet may result in the [ERR41 MOTOR B] error.
In this case, set the sheet setting to [HEAVY].
Set the offset value of the automatic feeding function [FEED OFFSET]
Set the offset value to feed with a little extra.
When performing the auto feeding function, a paper tube may move loudly in case of the roll sheet
comes up to the wire. Feed the roll sheet with a little extra to keep staying on a roll bar.
Setting value
0 to 100 cm
Cut off the sheet automatically after completing cutting operation [AUTO. CUT]
Perform the sheet cut automatically after completing cutting operation/
The automatic sheet cut function is effective when a roll sheet is selected ( Refer to 2.14 ).
Cut timing:
When in use of a roll sheet, perform the cut off operation automatically after completing the first data
cutting.
When performing [No.COPIES], or copying the registration marks continuously, the first line is cut off after
completing the second line cutting.
Summary of Contents for CG-FX SERIES
