- 4.4 -
Registering a type
The FUNCTION mode enable to regists 4 types.
If the type has been registered for each medium type, it becomes easy to change plotting conditions
when the medium type is changed.
Example) Type1 : ABS
Type2 : PS
Type3 : PCV
Type4 : check
STEPS:
1.
Make sure that the mode is LOCAL mode.
2.
Press the [FUNCTION] key.
3.
Press the [ENTER] key.
4.
Press the XY [ ] or [ ] keys to select any of
types 1 through 4.
5.
Press the [ENTER] key.
Setting Plotting Conditions.
(
page 4.5 through 4.7)
Changing the type
If plotting conditions for types 1 through 4 have already been registered, settings can be selected
according to the plotting simply by selecting the type.
1.
Perform steps 1 through 5 above.
Select a type.
2.
Press the [END] key.
Plotting with the plotting condition registered for the selected
type is possible.
<< LOCAL >>
X =1010
Y = 1860
FUNCTION
SETUP
< ENT >
SETUP
SELECT
: TYPE1
SETUP
SELECT
: TYPE1
Type1
Print Mode
< ent >
Summary of Contents for DM3-1810S
