- 2.7 -
Adjusting the suitable temperature of heater
Before turning on the heater power, set the appropriate temperature for the garment in use.
• Do not touch the heater part for the part (on the table) is heating up while
the heater is on, or it may cause burns.
• Use the device under the condition at 20-35
°
C. Depends on the tempera-
ture condition, the heater temperature may not rise to the set temperature.
• Depends on garment or the environment, the appropriate temperature may
differ. Raise the temperature of a heater until the print is clear and vivid.
For a 100% cotton garment, the appropriate temperature is around 50-60
o
C.
However, if you raise the temperature too much, the effect of discharge
becomes difficult to be obtained.
STEPS:
1.
Reverts to the LOCAL mode.
Press the [REMOTE] key to put the device back into the
LOCAL mode.
2.
Press the [FUNCTION] key.
3.
Press the [ENTER] key.
4.
Select the type by pressing the JOG keys [ ]
and [ ].
page 4.4
5.
Press the [ENTER] key.
6.
Select [HEATER] by pressing the JOG keys [ ]
and [ ].
7.
Press the [ENTER] key.
8.
Press the [ENTER] key.
9.
Set the temperature by pressing the JOG keys
[ ] and [ ].
• Set the lower heater temperature for a thinner
garment. For the thicker garment, set the higher
temperature.
10.
Press the [ENTER] key.
11.
Press the [END] key three time.
The menu reverts the LOCAL mode.
12.
Turn on the power of the heater.
CONSTANT indicator lights in green when the heater
reaches the set temperature.
page 1.6
< LOCAL >
width : 610 mm
FUNCTION
SETUP
< ENT >
SETUP
SELECT
TYPE 1
SETUP
SELECT
: TYPE 2
TYPE 2
FEED COMP.
< ent >
TYPE 2
HEATER
:< ent >
TYPE 2
PRINT HEAT
< ent >
TYPE 2
PRINT HEAT
: 50
o
C
OFF / 20-60
o
C
OFF / 68-140
o
F
TYPE 2
PRINT HEAT
< ent >
< LOCAL >
width : 610 mm
Summary of Contents for GP-604D
