- 2.19 -
To replenish ink, set a new ink cartridge in the ink station
If ink in the cartridge comes to an empty, the corresponding message appears.
Plotting can be continued, however ink may run out during plotting.
Immediately put a new ink cartridge.
• In case [NEAR END] is indicated on the LCD, replace a ink cartridge in
good time.
When carrying out continuous output, start printing after checking the ink
level. In case ink finished during printing, the operation stopped.
If replenishing ink during printing, it may result in color change.
• [NEAR END] for washing liquid can not be detected. Only [INK END] is
detected
< When the amount of ink becomes small during plotting >
Indicates the ink color which has run out.
Display shows on the right indicates that black ink comes
to an end.
• If [NEAR END] for discharge liquid is de-
tected, discharge liquid does not fire on next
data therefore replace to the new discharge
liquid as soon as possible.
< When the amount of ink completely runs out during plotting >
Indicates the ink color which has completely run out.
Display shows on the right indicates that cyan ink runs out.
STEPS:
1.
The messages displayed on the LCD during
plotting.
•
When [INKnearEND] appears, the LOCAL mode is
resumed and the operation stopped each time plotting
of a single data is completed. Proceed to Step 2 at the
end of the plotting operation.
•
When [INKEND] appears, plotting cannot be continued.
2.
Install a new ink cartridge.
Pull out the indicated ink cartridge and then set a new ink
cartridge.
3.
The menu enters the REMOTE mode.
Continuous plotting is possible.
< LOCAL >
NEAR END
K - - - - - - -
< LOCAL >
INK END
- - M - - - - -
< LOCAL >
NEAR END
K - - - - - - -
∗
REMOTE
∗
TYPE. 1
2. 5
Summary of Contents for GP-604D
