- 4.11 -
Set the print area
This device enables to specify the print area as following two methods.
page 4.9
Two methods (POINT/AREA) are able to switch with the function [LED POINTER].
The specified print area is read by RasterLinkGP (output software) and output data are created
accordingly. Refer to the RasterLinkGP user manual for details.
1. POINT
- Specify the printing point -
Specify one point (P1) to determine the printing point.
1. Specify the base point (P0).
2. Specify another point (P1) to determine the printing point. Create an output data
according to the point specified.
P0 : Base point
P1 : Printing point
Origin
e.g) When printing at 200 mm lower on the left neck side
1. Set the left neck side as the P0 point (X,Y).
2. Determine the P1 point (X-200, Y) based on the P0 point.
3. Read the data into the RasterLinkGP.
If determined the printing base point on the RasterLinkGP,
it enables to print accurately on the specified position even
if printing characters differ in number.
e.g) Print as centering the P1 point
Summary of Contents for GP-604D
