- 2.17 -
Heat with a press
Place the garment (T-shirt) on the pressing machine to settle the ink.
• Avoid contact of printed area with the white area. The wet ink may smear
the white area.
• Use a special pressing machine. Extra-high temperature may burn the
material. The desired fastness to washing may not be obtained when an iron
is used for the optimum setting condition cannot be maintained easily.
• The time interval between after plotted the garment (T-shirt) and before
performing the posttreatment should be always at a regular time length. If
the time interval differs at each time, it may cause color differences between
the plotted garments (T-shirt). Make sure to perform the posttreatment after
drying the garment completely, or the inks absorbed by the disposal paper,
and it may cause the color differences on the plotted garment.
• When used discharge liquid, be sure to heat by pressing machine within 5
minutes after printing. Otherwise effect of discharge decrease.
STEPS:
1.
Place a sheet of paper over the printed area
and heat with a special pressing machine.
Pressing machine
Temperature
160
°
C
Time
60 seconds
Pressure
0.45 kg/cm
2
• The heating condition varies by the T-shirt
material or the performance of the heater.
Determine the optimum condition carefully.
• The fastness to washing varies by the T-shirt
material or post-print treatment. Determine
the optimum condition carefully, and verify in
a color fastness test.
• Color fastness and color development are
greatly affected by the work environment
(room temperature, heater temperature).
Printing under the identical work condition is
highly recommended.
Reference
Summary of Contents for GP-604D
