- 4.14 -
<LOCAL>
Width : 610 mm
ORIGIN SET UP
0. 0
0. 0
ORIGIN
X = 300
Y = 300
Origin(Length)
Origin(Width)
Set the ORIGIN
The origin needs resetting to test nozzles and other functions at the time the plate is set in place.
For normal printing operation, the origin must be determined on RasterLinkGP (output software),
STEPS:
1.
Press the JOG keys[ ],[ ],[ ] and [ ] to move
the carriage to the origin position.
•
Blinking value of the LED POINTER indicates
the display coordinate.
2.
After determining the origin, press the [ENTER]
key.
The effective plotting area is displayed on the LCD, and the
menu returns to the LOCAL mode.
When the device starts plotting the next time, it uses the
origin that has been determined unless the origin is changed.
If a sensor detects the garment when the carriage begins to move or moving
• If a sensor detects the garment when the carriage begins to move or mov-
ing, moving is stopped and an error message displayed on the panel. In that
case, follow the procedure below.
STEPS:
1.
Press the Z key [ ].
The head moves up.
2.
Press the JOG keys[ ],[ ],[ ] and [ ] to move
the carriage to the origin position.
3.
After determining the origin, press the [ENTER]
key.
ERROR71
WORK TOO HIGH
ORIGIN
Z Height
8.0
<LOCAL>
Width : 610 mm
Summary of Contents for GP-604D
