- xv -
CAUTIONS and NOTES
Handling of ink cartridges
•
Use the JV3 genuine ink. Remember that the
user shall be charged for a repair to correct any
damage resulting from the use of ink other than
the exclusive type.
•
The printer does not operate with other ink than
the JV3 genuine ink.
•
Do not use the JV3 genuine ink for other
printers as doing so may cause damage to other
printers.
•
Never refill the ink cartridge with ink. Refilling
the ink cartridge can cause a trouble. Remem-
ber that Mimaki assumes no responsibility for
any damage caused by the use of the ink
cartridge replenished with ink.
•
If the ink cartridge is moved from a cold place to
a warm place, leave it in the room temperature
for three hours or more before using it.
•
Open the ink cartridge just before installing it in
the printer. If it is opened and left for an ex-
tended period of time, normal printing perfor-
mance of the printer may not be ensured.
•
Make sure to store ink cartridges in a cold and
dark place.
•
Store ink cartridges and waste ink tank in a
place that is out of the reach of children.
•
Be sure to thoroughly consume the ink in the ink
cartridge, once it is opened, within three
months. If an extended period of time has
passed away after opening the cartridge tank,
printing quality would be poor.
•
Neither pound the ink cartridge nor shake it
violently so as to prevent leakage of ink.
•
Do not touch or stain the contacts of the ink
cartridge as doing so may cause damage to the
print circuit board.
•
Waste ink is equivalent to waste oil of industrial
waste. Request an industrial waste processor
for processing of waste ink.
Power supply
•
Leave the breaker turned ON.
•
Do not turn OFF the main power switch on the
rear face.
Front cover and lever
•
Never open the front cover and/or lever during
printing. Opening the cover or lever will abort
printing.
Protection against dust
•
It is strongly recommended to use the device in
a room that is not dusty. Set the Refresh level 2
or 3 when in bad environment. (
page 4.9)
•
Keep the front cover to be closed also when the
device is not engaged in printing. If not, dust can
accumulate on the head nozzle.
•
When leaving the workshop after the working
hours, be sure to take off any media from the roll
hanger. If any media is left on the roll hanger,
dust can put on it.
•
Store media in a bag. Wiping off dust accumu-
lated on a media will adversely affect the media
due to static electricity.
•
Frequently wipe the capping station clean to
eliminate dust and paper chips.
•
Dust in the head will also cause drops of ink to
fall abruptly down on the media during printing. If
this phenomenon takes place, be sure to clean
up the head. (
page 2.23, 4.10)
Media
•
If media that is likely to tightly curl, flatten first
the paper before using it for printing. Heavily-
curled media affect the printed result.
Locking the casters
•
Make sure to lock the
casters before starting
job. If the device
performs plotting without
the casters locked, the
device can move out of
position.
Periodic exchange parts
•
There are some parts which must be replaced by
service men. You have to make a contract with
distributors or dealers for after-sale service.
Summary of Contents for JV3-130SPII
