- 2.8 -
Setting the media on the device
The media that can be used with the device are roll media and leaf media.
Use the media commended by MIMAKI.
•
If a transparent media is set, the following message appears on the LCD
and the media may not be detected.
•
If the media is exposed to direct sunshine, the media width may not be
detected correctly.
•
Do not use printed media, or ink adheres to a pinch roller and media may
not be detected.
•
Strong or internal curled media must be set to be along the platen by rolling
it in the opposite direction.
Changing the drier fan angle
Enable to change the angle of the drying fan to the two directions as “Media set” or “Print”.
Change the angle in need.
STEPS:
1.
Loosen the upper knob screws at both sides
of the drier fan.
2.
Select a angle as setting.
Set the print position as plotting.
3.
Retighten the knobs.
ERROR 50
MEDIA SENSE
Summary of Contents for JV3-130SPII
