- 4.8 -
INK LAYERS
P. A.6
Sets the number of overwriting if ink coloring is poor.
(1-9 times)
DRYING TIME
P. A.6
This function sets an ink drying time. It sets the function for drying ink.
The drying time is the wait time by scanning and the time interval between the instant at
which the plotting operation is completed and the instant at which the media plotted is
cut off.
Specify the time to be established in accordance with the printing resolution on a draw-
ing and the type of media to be used.
SCAN :
Sets the time of temporary stop at the capping station during the reciprocating
motion of the head. (0.0-9.9 sec)
• When 3 seconds or longer pause is specified, once the head is
capped, for the ink blockage protection function works.
AUTO CUT :
Sets the time between the end of plotting and media cutting.
However, the AUTO CUT function needs to be enabled. (0-999 sec)
AUTO CUT
P. A.6
This function cuts off the media automatically at the end of plotting.
If AUTO CUT is not specified, the device plots the next plotting data after plotting the
current data, without cutting off the media.
(ON, OFF)
Even if AUTO CUT is not specified, you can cut off the media by hand.
page 2.29
PRIORITY
P. A.6
Specifies whether the values set on the device (panel) are given priority or the values
set on the computer (host) are enabled as for the following seven functions.
(HOST, PLOT)
•
MEDIA COMP.
•
HEATER
•
PRINT MODE
•
INK LAYERS
•
DRYING TIME
•
AUTO CUT
•
REFRESH
•
VACUUM
Summary of Contents for JV3-130SPII
