- 2.9 -
Setting a roll holder
•
Attach the roll holder with two people.
The attachment position (height) of the roll holder can be set in three steps.
Depending on the media, change the attachment position of the roll holder by reducing or
increasing the heater contact time.
To reduce the heater contact time, attach the roll holder at the top position ; to increase the
heater contact time, attach it at the bottom position.
When it is attached to the top or bottom position, it is necessary to use the lock pin to set
the media.
page 2.16
STEPS:
1.
Remove the four screws, and then remove roll
assembly.
2.
Remove the 3 roll guide rails.
3.
Attach the roll guides rail to another position.
Summary of Contents for JV3-130SPII
