© 2014 MIMAKI ENGINEERING CO.,LTD.
4.3.9
P.1
1
2
3
4
5
6
7
8
R.1.0
4.3.9 Parallelism adjustment of the Tension Bar
Outline
This device is an option product.
Perform parallelism adjustment between the T bar of the Tension-bar take-up unit and the Roll shaft.
After the parallelism adjustment between the T bar and the Roll shaft, measure the distance between the PR shaft and
the Roll shaft at the printer’s both edges by using anelastic wire. Based on the distance measured at one side, if the
other side is misaligned with the standard, adjust it as the Roll shaft is not parallel.
Work procedure
T bar parallelism adjustment: Confirm the parallelism of the T bar 160 and the Roll shaft by measuring the dis-
tance of both.
1. Fix the level foot.
2. Lower the T bar 160.
3. Wrap a wire with a mark (tape) around the T bar 160 and the
roll shaft, and measure the distance between the T bar 160 and
roll shaft.
Measure both the left and right sides. If there is a difference,
perform the following adjustment.
Roll shaft (paper tube)
T bar 160
T bar 160
Check the gap between right and
left
Roll shaft
Wire
Apply tension appropriately to the wire.
Be careful not to raise the T bar due to the tension of
the wire.
MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Parallelism adjustment of the Tension Bar
Model
JV300-130/160
Issued 2014.05.30 Revised
F/W ver.
1.00
Remark
1.0
Rev.
Summary of Contents for JV300-130 A
Page 243: ......
Page 244: ...D500946 10 30052014 MIMAKI ENGINEERING CO LTD 2014 KF FW 1 1 ...
