Set the start position of drawing
41
Set the start position of drawing
1
Press the
key in the local mode.
2
Press the
to select [Kebab Origin
Set].
• The [Kebab Origin Set] menu is displayed only when installing the Kebab MkII (MkII L) system.
• Enter the diameter of the work before selecting the menu as the table height differs depending on the diame-
ter.(
3
Press the
key.
• The table moves up and down depending on the diameter of the work, and the table moves forward.
• If a warning message “WORK High” is displayed while the table is moving forward, refer to P.31 “Set a work”
on page 14 and set the work diameter again, and then start from step 1.
• Once the table has finished moving, the mode is set to the Kebab origin
point setting mode.
• When [OriginMarkSearch] is “ON”, start Origin mark detection.
4
Press
, and move the red light
pointer “
●
” mark over the work.
• Move the light pointer mark to where you want to draw, and then set the
origin point position.
• When you press
, the slider moves sideways.
• When you press
, the work over Kebab rotates.
5
Press the
key when the drawing ori-
gin is determined.
• The origin is changed.
• If you press the [END] key without pressing the [ENTER] key, the settings you have made up to
step 4 is canceled, and the work you have set over Kebab rotates and moves back to the position
before the setting menu.
M E N U
1 / 3
WO R K S E T
>
MENU
M E N U
1 / 2
K e b a b O r g i n S e t
>
ENTER
O R I G I N S E T U P
0 . 0
- - - - -
O R I G I N S E T U P
1 0 . 0
0 . 0
Rotation distance
of the work
Origin position
(right and left)
O R I G I N S E T U P
Y = 3 0 0
ENTER
