How to Set the Work
3-3
How to Set the Work
Set a work on the clamp table.
Although the reference setting position of works differs
by CAD to be connected, generally set on the follow-
ing positions.
Upper-left corner (A shown on the right figure) or
Lower-left corner (B shown on the right figure)
Determine the setting position of works depending on
the CAD used.
For setting works, there are two ways as follows.
Stop rotation of the spindle when setting a work and change to the local mode.
If this machine receives data in the remote mode, the spindle rotates and the head starts to
move. If the spindle rotates during setting the works, it could cause injury including fracture of
fingers or hands, avulsion of nails, or burn.
Before setting a work, stop rotation of the spindle and change to the local mode.
Set a work firmly.
Set a work properly and firmly following the instruction of this manual.
If not set firmly, engraving accuracy may reduce or the work may come off and cause an injury.
?
?
Reference Scale
Clamp Table
Front
Summary of Contents for ME-300STII
