4-12
Registering an Origin for the G-code
Work Coordinates System
If a command is set to a G-code, you can register, in six locations, the X, Y, and Z axes of a work coor-
dinates origin serving as the reference point for the cutting position for each work.
The registration procedure is shown as below.
To select a registered work coordinates origin, specify it from the software you are using, or set it by
selecting the work coordinates system in the G-code setting items.
In addition, this function is compatible with firmware version 1.40 or later.
1
Press
(or
) to display
the fourth page of the local mode.
2
Press
(or
) to display
the screen shown on the right.
Using
(or
), select the work coor-
dinates origin you want to register.
(Origin option 1 to 6)
3
Press
(or
) to display
the screen for setting the selected work
coordinates origin.
The displayed numerical values for the axes indicate
the distances from the values set for the currently
selected work coordinates origin.
4
Use
to move the head to
the target position.
•
While
is held down
t o g e t h e r , t h e m o v i n g s p e e d
increases.
•
Press
, and you can
change the transfer unit for the X
and Y axes.
(0.1mmn0.01mm)
•
Press
, and you can
change the transfer unit for the Z
axis.
(0.1mmn0.01mm)
[ L C L ] S p i n - O F F 4 / 4
Z
S t a n d a r d
- - >
G - c o d e
- - >
G - c o d e
O r i g i n - - >
F 2
< G W o r k
O r i g i n >
O r i g i n
S e l e c t
1 >
S e t
O r i g i n . 1
- - >
F 1
F 2
< W o r k . 1 > S p i n . O F F
X a x i s
2 0 . 0 0 mm
Y a x i s
0 . 0 0 mm
Z a x i s
- 3 0 . 0 0 mm
< W o r k . 1 > S p i n . O F F
X a x i s
- 5 . 0 0 mm
Y a x i s
1 0 . 0 0 mm
Z a x i s
- 1 0 . 0 0 mm
Summary of Contents for ME-300STII
