8
Definition of Term
This section explains keywords of this manual.
Tool
The instrument mounted on the head
(spindle) when engraving is called Tool.
The tools used on this machine are as fol-
lows:
Cutter
Endmill
Chip removal attachment
Vacuum hose
Host
Host computer is called Host for short.
Work
Engraving material including acrylic, stain-
less and ABS is called Work.
X axis ・ Y axis ・ Z axis
Movement of this machine from right to left,
front to back, top to bottom is called X axis,
Y axis, and Z axis respectively.
X and Y axis origin
The bottom left point of engraving data is
called X and Y origin.
Z axis reference point
The reference point of cutting amount or
raising amount is called Z axis reference
point.
G-code
An NC-code that this machine can interpret
and execute is called a G-code.
G-code is compatible with firmware version
1.40 or later.
Flatness follow-up function ON
The work surface (Z axis reference point)
is automatically detected and engraved
every time of up / down of the cutter.
Flatness follow-up function AUTO
The work surface is detected not only
when up /down of the cutter, but during cut-
ting.
Even an undulating work or a work with
slanted surface can be engraved at a con-
stant depth.
At work
The state of engraving received data, mov-
ing the head or the table using the opera-
tion panel, or performing self-test is called
At work.
Standby
The state of waiting for data in the remote
mode is called Standby.
Moving part
The head and the table are called Moving
part.
During engraving
The state of engraving received data or
performing self-test is called During
engraving.
Summary of Contents for ME-300STII
