6
Warning for Use
WARNING
• Do not use the machine in a poorly ventilated room or a closed room.
• Take care not to damage, break or work upon the power cable. If a heavy material is placed on the power
cable, or if it is heated or pulled, the power cable can break, thus resulting in fire or electric shocks.
• Avoid locating the machine in a damp environment. Do not splash water onto the machine. Use in such an
environment can give rise to fire, electric shocks or breakdown of the machine.
• Use it with the displayed power supply specifications. The power-supply voltage of this machine shall be
single-phase 200 to 240 Vac 30 A and less. (You cannot use this machine in the 100V system.)
• Use of the machine under an abnormal condition where it produces smoke or strange smell can result in fire or
electric shocks. If such an abnormality is found, be sure to turn off the power button immediately and unplug
the cable from the wall outlet. Check first that the machine no longer produces smoke, and then contact your
distributor or a sales office of MIMAKI for repair. Never repair your machine and ink bottle by yourself since it is
very dangerous for you to do so.
• Never disassemble or remodel the main unit of the machine or the ink bottle. Disassembly or remodeling can
result in an electric shock or breakdown of the machine.
• Take care that no dust or dirt sticks to platen heaters. Dust and dirt sticking heaters can cause fire.
Hazardous Moving Parts
Keep Fingers and Other Body Parts Away
• The main power circuit breaker should be set ON only by personnel with sufficient knowledge about operations
of this unit.
• Do not touch the LED UV unit and Post cure unit on or right after the lamp off with bare hands to avoid from
burn injury.
Handling the Anti-freezing liquid
• Use the exclusive Anti-freezing liquid by Mimaki ,or the LED UV cooling device may be damaged.
• If the Anti-freezing liquid or mixed soft water with anti-freezing liquid gets on the skin or clothes, immediately
wash it off with soap. If you get the Anti-freezing liquid or mixed soft water with anti-freezing liquid in your eyes,
immediately wash your eyes with a lot of clean water. Then, consult a doctor as soon as possible.If high
temperature Anti-freezing liquid or mixed soft water with anti-freezing liquid gets on the skin, immediately wash
it off with soap and cool with iced water. Then, consult a doctor as soon as possible.
• Before using the Anti-freezing liquid, be sure to read the Material Safety Data Sheet (MSDS).
• If you swallowed the Anti-freezing liquid or mixed soft water with antifreezing liquid accidentally, try to get to
vomit, and then consult a doctor as soon as possible.
• When unused the Anti-freezing liquid or used mixed soft water with anti-freezing liquid should discard as
followings,
nIncinerating the fluid which is absorbed to the sawdust or waste cloth.
nEntrust them to an industrial waste disposal contractor, clarifying their contents.
• Avoid ignition such as static electricity and impact spark.
• Be sure to wear goggles and gloves for handling the Anti-freezing liquid.
Handling of LED UV unit and Post cure unit
• Do not use the LED UV and Post cure unit in an ambience with a possibility of catching fire (gasoline,
combustible gas spray, thinner, lacquer, powder dust, etc.). In addition, do not put paper or cloth near or on the
LED UV and Post cure unit, or it may cause fire.or it may cause electrical shock.
• Never look at the LED UV and Post cure unit being lit with your naked eyes,or it may cause pain in your eyes
or visual impairment.Be sure to wear safety glasses.
• Do not apply ultraviolet (UV) light directly to your skin,or it may cause irritation on your skin.
• It is recommended to replace the LED UV unit and Post cure unit within the rated life.
Disposition of this machine
• When discarding this machine, request the treatment of it for an industrial waste disposal contractor.
• Treat it properly in compliance with regulation in the local area.
