2-6
5
On the backside of unit, set the feeding
device.
If the print-side is inside of roll,
(1)
Set the Feeding direction switch at the
“Forward” position (upward).
If the print-side is outside of roll,
(1)
Set the Feeding direction switch at the
“Backward” position (downward).
6
Raise the tension bar on the backside to
the highest position, and lock the bar.
7
Pass the media through under the tension .
8
Set the feeding manual switch to "Manual",
and pull the media a little longer.
• Pull the media out of the roll so that the media can
be grasped from the front of the machine.
9
Slide the media from the back to the front.
• Make the Feeding manual switch “AUTO”.
10
Close the rear cover.
Backward
Feeding with the print side facing to
the inside.
OFF
Not operated.
Manual
Auto
Feeding direction switch
Forward
Feeding with the print side facing
to the outside.
Feeding manual
switch
Tension bar
Lock
Tension bar
• Insert the roll media between the platen and the
pinch roller, and slide it to the front.
• Pull the media out to the front of this machine with
enough length.
• You can injure your hand if setting the roll media
with a bare hand due to the narrowness of the
media feeding route. Wear gloves when setting
the roll media in order to prevent injury.
Feeding manual
switch
Manual
Auto
Feeding direction
switch
Route for the paper of
its print-side inside.
Route for the paper of
its print-side outside.
Summary of Contents for SIJ-320UV
