- 3.18 -
Setting a unit of length displayed on the LCD [MM/INCH]
This function sets a unit of set values displayed on the LCD.
Use this function when displaying “width” and “length” of the fabric after setting of the origin or
detection of the fabric. When the device is shipped from the factory, the unit of display is set to MM
(millimeter).
MM
:
Numerics are expressed in millimeters.
INCH :
Numerics are expressed in inches.
STEP
1.
Select a type.
(See page 3.4). Here, select [Type.1].
2.
Push the [ENTER] key.
3.
Push the [ ] and [ ] key until the display gives
the indication [MM/INCM].
4.
Push the [ENTER] key.
5.
Set a unit of length displayed on the LCD by
pushing the JOG keys [ ] and [ ] .
Here, select [MM].
6.
Push the [ENTER] key.
7.
Push the [END] key twice, and the menu re-
turns to the LOCAL mode.
SET UP
SELECT
: TYPE.1
TYPE.1
MEDIA COMP.
< ent >
TYPE.1
MM/INCH
< ent >
TYPE.1
MM/INCH
:
MM
TYPE.1
MM/INCH
: INCH
TYPE.1
MM/INCH
< ent >
<< LOCAL >>
width : 1272mm
Summary of Contents for TextileJet Tx2-1600 Series
