- 3.22 -
Correcting amount of cloth feed while checking printing condition [MEDIA COMP.]
Even if you use cloths of the same type, the optimum amount of cloth feed differs according to slight
difference in weave of thread.
In addition, even if you use the same cloth, plotted image may contain stripes when printing data
with different print ratio. In this case, you can correct the amount of cloth feed while checking the
printing condition.
•
To change the cloth type or printing data, be sure to perform
[MEDIA COMP.].
•
This function can be activated even during data printing.
You can enter correction values while checking the cloth condition and data
printing condition.
STEP
•
During printing, [MEDIA COMP.] does not plot correction patterns. It only
allows you to enter correction values.
1.
Push the [ ] and [ ] JOG key until the display
gives the indication [MEDIA COMP.].
2.
Push the [ENTER] key.
3.
While checking the printing result, push the
[ ] and [ ] JOG keys to enter correction val-
ues.
4.
Push the [ENTER] key.
5.
Push the [END] key twice, and the menu re-
turns to the LOCAL mode.
TYPE.1
MEDIA COMP.
< ent >
TYPE.1
ADJUST
= 0
TYPE.1
ADJUST
= 10
TYPE.1
MEDIA COMP.
< ent >
<< LOCAL >>
width : 1272mm
Summary of Contents for TextileJet Tx2-1600 Series
