- 4.11 -
When the message [Replace Wiper] is displayed [WIPER EXCHG]
The wipers are consumable parts. As the wiper continues cleaning the head, it gets stained with ink
and dust. When the message [RIPLACE WIPER] is displayed, replace the wiper with a new one
without delay. When replacing the wiper, remove ink adhered at the bottom surface of the slider.
•
The wiper is separately available from your local distributor or our office.
•
Do not push the [ENTER] key othe than the case of replacing wipers. The
number of wiper operations that is caunted in the Device will be reset. Do
not select [REPLACE WIPER] unless the wiper is to be really changed.
The message [RIPLACE WIPER]
The device counts the number of times the wipers are cleaned and tells when to replace them. When
the message [RIPLACE WIPER] is displayed on the LCD, replace the wipers with new ones.
•
The message [RIPLACE WIPER] is displayed
while the device is in operation or when the
device power is switched on.
When the message is displayed, replace the
wipers with new ones.
STEP
1.
Put the device into the FUNCTION mode.
(See page 4.3)
2.
Push the [ENTER] key.
3.
Push the [ ] and [ ] key until the display gives
the indication [STATION].
4.
Push the [ENTER] key.
5.
Push the [ ] and [ ] key until the display gives
the indication [WIPER EXCHG].
6.
Push the [ENTER] key.
The carrige will come out of the capping station.
< L O C A L >
RIPLACE WIPER
FUNCTION
MAINTENANCE
< ENT >
MAINTENANCE
LIST
< ent >
MAINTENANCE
STATION
< ent >
MAINTENANCE
MENT : CARRIAGEout
MAINTENANCE
MENT : WIPER EXCHG
STATION
COMPLETED
: ent
Summary of Contents for TextileJet Tx2-1600 Series
