- xv -
Handling the Anti-freezing liquid
•
Be sure to store the Anti-freezing
liquid in a cold and dark place.
•
Store the Anti-freezing liquid in a
place that is out of the reach of
children.
About UV light
•
Some UV light leaks from the
openings for carrying in/out media.
UV light applied to your skin might
cause inflammation and/or skin
cancer. Though weak UV light might
cause no inflammation, repeated
exposure to it may lead to chronic
disorders. Avoid applying UV light to
your skin and eyes.
•
Impairment of eyes caused by UV
light may be:
Acute disorders ... Pain in eyes, tearing,
etc.
Chronic disorders ... Cataract, etc.
When using this device, take
protective measures such as gloves,
long-sleeve cloth, light-resistant mask,
attached light-resistant glasses, etc.
About cleaning
•
After using the unit long time, foreign
materials and dust may be gathered
on the conductive and insulating
parts, causing electric leakage.
Periodically clean such parts.
•
For cleaning, do not use compressed
air because it scatters foreign
materials and dust, which may cause
malfunctions when put inside the
conductive parts. Be sure to use
vacuum cleaner for cleaning of foreign
materials and dust.
•
Do not use the unit in a place where
there is a possibility of being wet, or
electrical leakage may occur.
•
Electrical leakage, if it should occur,
may lead to electrical shock of
personnel or fire.
•
In order to prevent accidents from
occurring, be sure to carry out
periodic inspections and replacement
of time-change components.
About hot parts
•
The UV lamp and the interior of the
UV irradiation device will have a very
high temperature. When carrying out
maintenance, wait until the
temperature has been sufficiently
lowered after the lamp is turned OFF.
•
Some parts outside the unit will have
a very high temperature. A high-
temperature caution label is placed on
such parts. Do not touch the parts
with the caution label placed and their
vicinity, or burn injury may occur.
•
When it is unavoidable to touch hot
parts, be sure to wear heat-insulating
gloves to protect your hands.
About firing and smoking
•
Touching hot parts such as the UV
lamp with combustible materials may
cause firing and/or smoking.
•
After the unit is used long time,
foreign materials or dust gathered on
the stabilizer or other parts may
cause electrical leakage or insulation
deterioration may cause firing and/or
smoking. Periodically clean the parts
and measure the insulation
resistance, replacing deteriorated
parts, if any.
•
After the unit is used long time,
screws, etc. on the conductive parts
may be loosened, causing firing and/
or smoking. Periodically tighten such
screws.
•
Because this unit is not of explosion
proof type, do not use it in an
ambience with hazardous materials,
or a possibility of explosion may arise.
•
If abnormal conditions such as
abnormal odor, smoking, traces of
CAUTION
Summary of Contents for UJF-605C
