2
Drill Hole Locations for Installation
Back Panel
Side Panel
Mounting Hardware Included
Note:
Installing the wire corner soapdish:
1. Determine the height of the soapdish before going any further. It would be best to check
blue prints and with the project manager before drilling any holes. Failure to do this could
cause unnecessary repair work, which can be time consuming and costly. Also, make
sure the soapdish is being installed in the correct corner.
2. Once the height of the soapdish is determined, make a pencil mark on the wall where
the top of it will be installed. Using the torpedo level, continue this line on the adjacent
wall in the corner.
3 The soapdish has three mounting brackets. One is located on the longer side, and the
other two are located on the short side.
Please Note:
If the soapdish is to be installed in the right corner, facing the shower,
the long side of the soapdish will be on the back wall and the short side will be on the
right shower panel. If the soapdish is to be installed on the left corner, facing the
shower, the long side of the soapdish will be on the left wall and the short side will be
on the back wall. (See diagram of soapdish)
