[4]
OPERATING INSTRUCTIONS
SETUP
The headphones connect to the headphone output jack (
). When using an
Extra User Package (
sold separately
), connect the 3.5mm splitter cable to the
Delight and connect each set of headphones to the splitter cable. It is
recommended that you disconnect the headphones from the unit before storing
or travelling to prevent accidental damage to the jack.
The Tru-Vu Omniscreen, Tru-Vu Omniscreen Viewhole, or Tru-Vu Omniscreen
Multi-Color Eyeset connect to the eyeset output jack (
) with the included
2.5mm patch cord. Connect one end to the Delight and the other to the jack
located on the lower left of the glasses. When using an Extra User Package (
sold
separately
), connect the 2.5mm splitter cable to the Delight and connect each
eyeset to the splitter cable. It is recommended that you disconnect the eyeset
cable from the device and from the eyeset before storing or travelling to
prevent accidental damage to the jacks.
An external audio source (such as an MP3 or CD player) can be connected to the
Delight so that music or other audio can be listened to while running a session.
Plug the stereo patch cord into the headphone output of the audio device and
the audio input jack ( ) of the Delight.
Note: start the Delight and select a session before playing audio unless you
would like to run a Sound Sync Session (see page 9).
POWER
The Delight can be powered with a 9-volt alkaline or rechargeable battery, or
with the 9-Volt adapter provided. To install the battery, slide the cover off of the
battery compartment on the back of the unit. Insert a 9-volt battery as indicated
on the diagram in the battery compartment. Slide the cover back into place. An
alkaline 9-volt battery will provide approximately seven (7) hours of operation
To use the 9-Volt adapter, connect the adapter to the 9-Volt jack (
) on the
side of the unit. The 9-Volt DC power adapter uses a 1.3mm center-positive
plug. No battery power is used when plugged into an adapter.
