2
Indoor Receiver Set-up (that’s the bigger unit with lots of information):
We suggest you familiarize yourself with the control buttons. You’ll need to press most of these at some point
during the set-up procedures.
Insert 2AAA batteries in the rear (if nothing happens on the front, you put them in wrong!!) Check the +
and – directions.
The unit will beep once and then start searching for a signal (from the transmitter you set up earlier). We
suggest you have the RS220 transmitter close at hand for this initial set-up.
You will receive the remote temp/humidity readings within 3 minutes (usually within 30 seconds). The
receiver will automatically switch to the correct channel. If not, press “CH” (top of large silver button)
until you get to whatever channel you set the RS220 to.
To switch between C and F, press the “Down” button (doesn’t that make a lot of sense!!).
So, now you have the in/out temp & humidity, and a weather forecast symbol. You can pretty well ignore the
forecast as it needs at least 12 hours of pressure/humidity information to establish a trend. Please note for
accurate forecasts, the unit should be placed somewhere outside the main house (especially if you are running
air conditioners).
What’s Left??
-
Date & Time
-
Setting Time Alarms
-
Setting Temperature Alarms
-
Reading Min. Max. records
For most users, the first two are most used. You have 8 to 10 seconds to input the next piece of information,
otherwise the unit will go back to the beginning of whatever you were trying to program! In order for all to go
smoothly, you need to know the year, month, day, as well as hour and minute before you start.
That’s the bad news. The good news is you can do it as often as you like or until you get it right! It’s really not
that hard. It just takes a little getting used to and some patience.
Date and Time Set-up:
Press & hold the “TIME” button for 2 seconds – Year will flash
Press UP or DOWN to adjust. Press “TIME” to confirm.
Month flashes next. Press UP or DOWN to adjust. Press “TIME” to confirm
Day flashes next. Press UP or DOWN to adjust. Press “TIME” to confirm
One of 7 languages flashes next!! Press the UP button to scroll through. When you see a language you
recognize, press “TIME” to confirm. Your choices are: EN (English), GE (German), FR (French), ES
(Spanish), IT (Italian), NE (Dutch) or DA (Danish).
Next comes the Hour, then Minutes, then Seconds. By now you know the procedure to complete the
programming.
1.
Set Alarm:
Press “Alarm” for two (2) seconds
Hour will flash → press UP or DOWN to adjust
o
Press “Alarm” to confirm → Minutes will flash
o
Press UP or DOWN to adjust
o
Press “Alarm” to confirm
You have now set the Alarm. The alarm “bell” Icon
appears (to the right of the time). This indicates the
alarm is activated. To deactivate, press “Alarm” one time and the “bell” should disappear.
To silence an alarm, press “Alarm” or “SNZ” if you need an extra 5 minutes!
