System Menu
Operations
2 - 10
0070-10-0666-01
Trio™ Operating Instructions
2.3.5.4
Analog Setup
The monitor can output an analog waveform from the analog output connector (AO1) on the
rear panel.
Select
ANALOG SETUP
from the
MONITOR SETUP
menu (see FIGURE 2-8). Select
ANALOG OUT
, to set analog out to
ON
or
OFF
. Select
ANALOG WAVE
to select the
parameter waveform output. Choices are
ECG
and
IBP
(optional).
Select
PREVIOUS MENU
to return to the previous menu. Select
NORMAL SCREEN
(from
the menu or the Front Panel Keypad) to exit the menu and return to the normal screen.
FIGURE 2-8
Analog Setup Menu
2.3.5.5
Module Setup
MODULE SETUP
allows the user to customize the display by selecting the parameters to be
monitored. Select
MODULE SETUP
from the
MONITOR SETUP
menu (see FIGURE 2-9).
FIGURE 2-9
Module Setup Menu
Select the parameters to monitor by using the Navigator™ Knob to select the item to be
displayed. A check mark will be displayed in the box next to each parameter selected. To
deselect a parameter, press the knob again (the check mark will be removed). Select
PREVIOUS MENU
to return to the previous menu. Select
NORMAL SCREEN
(from the
menu or the Front Panel Keypad) to exit the menu and return to the normal screen.
NOTE:
If the optional IBP is not installed, it will not be displayed in
the MODULE SETUP menu.
