— MIN.INIT
3.6 - Minimum load for application
— 1 DIGIT
3.6.1 - 1 digit*
Setting: [APPLIC.] - [CLER.CF] (3.24) (see chapter
7.9.2
Tare function
If you store a tare (weight value) by pressing the
key, you can later enter a tare value
manually. The tare value you enter is added to the stored tare value.
Setting: [APPLIC.] - [TARE.FNC] - [NORMAL] (3.25.1) (factory setting) (see chapter
).
A tare value entered manually overwrites a stored tare value (weight value). If you enter a
tare value manually, a tare value (weight value) stored later overwrites the manually
entered value.
Setting: [APPLIC.] - [TARE.FNC] - [SPECIAL] (3.25.2) (see chapter
7.9.3
Restore factory default settings
Setting: [APPLIC.] - [RESET] (9.1) (see chapter
).
7.9.4
Number of Measurements for Average
You can enter the desired number of weight measurements to determine the average
using the keypad.
Note:
The entered value remains active until deleted by pressing the
key or until
overwritten by a new value. It remains saved after the scale is switched of.
It also remains in memory when you switch to a diferent application program, or turn of
the scale.
7.9.5
Application Start
There are three ways to start the averaging routine:
-
Manual start with preset number of sub-weighing operations: Place the sample on
the platform and press the
key.
-
Manual start with user-deined number of sub-weighing operations: Place the
sample on the platform and enter the number of weighing operations using the
keypad. Press the
key to save the number entered and begin weighing.
-
Automatic start with preset number of sub-weighing operations: Measurement
begins when you place the irst sample on the platform, provided the start conditions
are met.
7.9.6
Available Parameter Settings
Description of the parameters:
-
Minimum load for application, see chapter
-
Starting the Measurements, see chapter
-
Display, see chapter
Menu tree of the parameters Averaging (Animal weighing):
ANIM.WG
Combics 2 Series Complete Scales Models CAW2P, CAW2S
7 Operating
EN-126
Minebea Intec
