9.3 Cleaning
9.3.1
Instructions for cleaning
9.3.2
Corrosive Environment
9.3.3
Cleaning the interior of the weighing platform (CAW… models only)
Take special care that no dirt gets into the gap of the overload protection (gap
between the load sensor and screw-on plate.
9.3.4
Cleaning the indicator
WARNING
Working on a device that is switched on can have life-threatening consequences.
Disconnect the from the power supply (pull the plug out of the socket) and, where
necessary, unplug the connected data cable.
NOTICE
Improper cleaning can cause signiicant damage to property.
No moisture should be allowed to enter the .
Do not use aggressive cleaning agents (solvents or similar).
Do not spray the device with water or clean it using compressed air.
The s comply with the guidelines of the EHEDG (European Hygienic Equipment Design
Group) regarding appropriate measures for preventing contamination. They are therefore
easy to clean and disinfect.
For use in the food industry, use a cleaning agent suitable for that particular working
environment.
9.3.5
Cleaning stainless steel surfaces
-
Only use commercially available household cleaners that are suitable for stainless
steel.
-
Use solvent only for cleaning stainless steel parts.
Remove all traces of corrosive substances from the device on a regular basis.
.
Remove the load plate. Special care is required for models larger than 1000 x
1000 mm.
.
Use compressed air to clean out the interior or use a weak water jet (max. 60°C).
.
Clean the with a cloth lightly moistened with a soap solution.
.
Wipe down the with a soft, dry cloth after cleaning.
.
All stainless steel parts must be cleaned at regular intervals: Wipe stainless steel
surfaces with a damp cloth and, if necessary, with cleaning agent; then thoroughly
remove all residues.
.
Allow the device to dry. Care oil can be applied as an additional protective measure.
9 Maintenance/repairs/cleaning
Combics 2 Series Complete Scales Models CAW2P, CAW2S
Minebea Intec
EN-193
