Pos.
Description
8
Battery charge status display
9
Symbol for activated GMP protocol
10
Unit of the displayed value
11
Number display e.g. for displaying the reference value
12
Symbol for data transfer
-
Interface initialized (Proibus/Ethernet/DeviceNet)
-
Flashes during data transfer (RS
‑
232/485)
13
Mem
Symbol for product data memory
14
In calibration mode with devices where
e
is not equal to
d
, the po-
sition marked with an outline must not be considered
15
AUTO/OPT
- AUTO:
- OPT:
A reaction of the application is triggered depending on the weig-
hed value
Automatic optimization carried out during the counting applicati-
on
16
Measured value line: Measured value or calculated value
17
Symbols for the applications: An active application is marked by
lines above and below the symbol ( ).
17
Appl.1
"Counting"/"Neutral measurement"
"Percentage weighing"
"Averaging" (animal weighing)
17
Appl.2
"Checkweighing"
"Classiication"
"Check against zero"
Manual dosing against "zero"
17
Appl.3
"Totalizing"
"Net total"
18
Zeroing symbol appears after zeroing the scale or the active
weighing platform (only in calibrated models)
19
+ –
Algebraic sign for the displayed value
20
Busy symbol indicates an ongoing process (internal processing)
3.3.3.2.2 Display in the menu mode
To describe the menu settings, in some cases text designations are used and in some
cases only the number structure of the menu, which allows experienced users to get their
bearings quicker (e.g. "menu item 1.9" contains the parameter settings for the calibration/
adjustment). The numerical menu is shown on the display if [CODES] is selected as the
language (see Chapter
The following diagrams show all important elements and symbols that may be visible in
the menu mode.
3 Device description
Combics 2 Series Complete Scales Models CAW2P, CAW2S
Minebea Intec
EN-21
