10 Appendix
10.1 Printouts
Printouts can be created by pressing the
Unit
key or using the control command "P". The
settings for printouts can be changed in the menu (see Chapter
).
Example printouts:
Printout for the Weighing application
Description
Note
11.11 kg N
1.23 kg T
11.11 kg N
12.34 kg G
MODE: WEIGHT
<no line printed>
Result line
Tare value line
Net value line
Gross value line
Mode line
Information line
If Printx → Content → Result = ON
If Printx → Content → Tare = ON
If Printx → Content → Net = ON
If Printx → Content → Gross = ON
If Printx → Content → Application mode = ON
If Printx → Content → Info = ON
Printout for the Weighing application with Totalizing application
Description
Note
11.11 kg N
1.23 kg T
11.11 kg N
12.34 kg G
MODE: WEIGHT
N: 4
TOTAL: 50.35 kg
MIN: 11.11 kg
MAX: 14.85 kg
Result line
Tare value line
Net value line
Gross value line
Mode line
Total line
Total line
Total line
Total line
If Printx → Content → Result = ON
If Printx → Content → Tare = ON
If Printx → Content → Net = ON
If Printx → Content → Gross = ON
If Printx → Content → Application mode = ON
If Printx → Content → Total = All
If Printx → Content → Total = All or Result
If Printx → Content → Total = All
If Printx → Content → Total = All
10.2 FCC notice
Note:
This device has been tested and found to comply with the limits for digital devices of
class B as per part 15 of the FCC regulations. These limits were created in order to ensure
appropriate protection against interference when operating in residential areas. This
device generates, uses, and may emit high-frequency energy and, if it is not installed
and used in accordance with the operating instructions, may cause interference with
radio communication. However, there is no guarantee that interference will not occur in
certain facilities. If this device causes interference with the radio or television reception,
which can be determined by switching the device off and then back on again, we
recommend one or more of the following measures to eliminate the interference:
-
Realignment or repositioning of the reception antenna
-
Increasing the distance between the device and the receiver
-
Connecting the device and the receiver to separate electric circuits
-
Call in the dealer or an experienced radio/television technician
10 Appendix
Compact scale Puro® - Basic
Minebea Intec
EN-55
