6.4.2.3
Printouts
Counting isn’t initialized:
Printout
Description
115 g OVER
- 115 g OVER
99 g ACCEPT
75 g UNDER
MODE: CHECKWEIGH
UNDER LIMIT 81 g
OVER LIMIT 100 g
positive netto value > high limit
negative netto value < negative high limit
positive netto value in target area
positive netto value < low limit
activated Application
Low Limit
High Limit
Counting is initialized:
Printout
Description
115 g OVER
- 115 g OVER
99 g ACCEPT
75 g UNDER
115 pcs
MODE: CHECKWEIGH
UNDER LIMIT 81 g
OVER LIMIT 100 g
WREF 0.35423 g
positive netto value > high limit
negative netto value < negative high limit
positive netto value in target area
positive netto value < low limit
netto count
activated Application
Low Limit
High Limit
piece weigh
6.4.3
Check number of pieces
-
Initialize Check count (see chapter
-
Running Mode (see chapter
-
Printouts (see chapter
)
6.4.3.1
Initialize Check Count
The
Button pressed long generates a minus sign in input mode on Display-Count.
Pressing
(Exit) Button the initialization process is left at once without storing a
new input or limit.
Pressing
(No) or
button briefly the blinking limit value is cleared and a
blinking cursor is shown on the right side ready for a new input.
Initialization is possible on both scales.
1.
After a Check Mode is selected press the
Button briefly.
[SET.LOW] is displayed on the Display-Weight.
Compact Scale Puro® Count
6 Application Programs
EN-26
Minebea Intec
