LED status
Description
Comments
1 Hz lashing green
Module is online (STOP).
-
There is a connection to the I/
O controller.
-
I/O controller is not operational
(STOP status).
-
IRT synchronization is not comple-
te.
3 Hz lashing green Identiication
Flashes continuously 3 times (1 Hz) in
order to identify the slave
(DCP_Identify).
Constant red
Critical event
Severe internal error
This display is combined with the red
module status LED.
1 Hz lashing red
Device name error
Device name was not deined.
2 Hz lashing red
IP address error
IP address was not deined.
3 Hz lashing red
Coniguration error
Expected identiication deviates from
the available identiication.
Module status (MS)
LED status
Description
Comments
Of
Module is not initialized.
-
No power
-
Module has the status "SETUP" or
"NW_INIT".
Constant green
Normal operation
Module no longer has the status
"NW_INIT".
1 Hz lashing green
Diagnostic event
Diagnostic event(s) is/are running.
Exception error
Module has the status "EXCEPTION"
Constant red
Critical event
Severe internal error
This display is combined with the red
network status LED.
Flashing green/red
in alternation
Firmware update
Do not switch of the module.
Switching of the module during an
update may cause permanent dama-
ge.
Process Controller Maxxis 5 PR 5900
4 Device installation
EN-116
Minebea Intec
Summary of Contents for Maxxis 5
Page 137: ......
