4. Device installation | 4.3 - Hardware construction | 49
4.3.7 ProfiBus-DP interface
With the Profibus-DP a centrally directed data exchange between master
and slaves is possible. The master (e.g. automation system PLC) carries out
the cyclic exchange of process data with the slaves (drives, I/O) one after the
other, in a fixed sequence.
Communication protocols and syntax comply with the ProfiBus-DP standard
to IEC 61158.
The interface can be configured by software.
Technical data
Description
Data
External connection
D‑Sub
9-pin plug connector (female)
Transfer rate
9.6 kbit/s to 12 Mbit/s, baud rate auto-detection
Connection mode
ProfiBus network, connections can be made/re
leased without affecting other stations.
Protocol
PROFIBUS-DP-V0 SLAVE to IEC 61158
Configuration
GSD file "MINE5215.gsd"
Bus termination
The bus termination in the last device is implement
ed via the integrated terminating resistor in the
ProfiBus plug connector.
Cable type
ProfiBus "special"; color: violet; screened twisted
pair cable
