5. Getting started | 61
5 Getting started
5.1 Switching on the device
The device is started up via a notebook/PC using an Internet browser.
Note:
The following steps must be followed when connecting the device to
mains voltage for the first time:
–
Assign password, see Chapter
–
Set the date and time, see Chapter
.
–
Set up the network (only necessary if the device is to be used or con
figured in the network), see Chapter
.
5.2 Switching off the device
The device is switched off by disconnecting the supply voltage (24 V) or by
loosening the plug connector.
5.3 Device warm-up time
A warm-up time of 30 minutes for the device is required before adjustment/
calibration is started.
5.4 Power failure
In the event of a power failure, all entered configuration, adjustment and
calibration parameters are retained.
