6. Operating | 6.12 - Configuring the analog output | 93
6.12 Configuring the analog output
The weight value of the weighing point is transmitted to the output.
: [Analog output] or [CombiCard]
The analog output can be configured according to the table below.
Parameter table
Parameter
Selection
Description
[Off]
Analog output is unused.
[Transparent]
Value output in D30.
Instrument is controlled via PLC.
[Gross]
Gross weight output in D8.
[Net]
Net weight output in D9; only if tared, other
wise gross weight is output.
[Mode]
[Select]
Gross/net value output on the display (D11) de
pending on SPM bit X72.
[0…20 mA]
Outputs 0…20 mA.
[Range]
[4…20 mA]
Outputs 4…20 mA.
[Hold]
If an error occurs, the analog output retains
the last value.
[0 mA]
If an error occurs, the analog output is set to
0 mA.
[4 mA]
If an error occurs, the analog output is set to
4 mA.
[Output on wgt. err.]
[20 mA]
If an error occurs, the analog output is set to
20 mA.
