2.7
Important note
Make sure that the construction of the device is not altered to the detriment of safety. In
particular, leakage paths, air gaps (of live parts) and insulating layers must not be
reduced.
Minebea Intec cannot be held responsible for personal injury or property damage caused
by a device repaired incorrectly by an operator or installer.
2.8
Repairs and maintenance
2.8.1
General information
Repairs are subject to inspection and must be carried out at Minebea Intec.
In case of defect or malfunction, please contact your local Minebea Intec dealer or service
center for repair.
When returning the device for repair, please include a precise and complete description of
the problem.
Maintenance work may only be carried out by a trained technician with expert knowledge
of the hazards involved and the required precautions.
2.8.2
Electrostatically sensitive parts
This device contains electro-statically sensitive components. Therefore, potential
equalization must be provided when working on the device (antistatic protection).
2.8.3
Replacing fuses
2.8.3.1
Replacing fuses in the Ex area
WARNING
Possible explosion due to improper replacement!
PR 5410 used in the Ex area: The replacing of fuses are not allowed!
2.8.3.2
Replacing fuses in a safe area
WARNING
Damage due to overheating.
The use of repaired fuses and bypassing the fuse holder is prohibited.
Only the fuses specified in Chapter
and
are permitted.
X3 Process Indicator PR 5410
2 Safety instructions
Minebea Intec
EN-14
