* Parameter [W&M] must be set to [none] before the calibration data is entered; see
Chapter
7.1.4
Restart
The PR 5410 is restarted using the front-panel keys.
Press the following keys one after the other:
-
SEtuP
appears on the display.
-
/
bIoS
appears on the display.
-
/OK
bIoS...
appears on the display.
FLASH
follows on the display.
-
/
boot
appears on the display.
-
/OK
Restarting has the following effects on the device:
-
Current process steps are deleted.
-
The device is reset to its factory settings.
-
The network settings are not changed.
7.2
Switching on the device
The device can be set up as follows:
-
Via keys on the front of the device
-
Via a notebook/PC using the VNC software (included on the CD)
-
Via a notebook/PC using an Internet browser
As soon as the device is provided with power, the display shows:
Pr5410
Message with device type PR 5410
b 1.00.00.
BIOS version
7 Commissioning
X3 Process Indicator PR 5410
EN-121
Minebea Intec