Depending on the settings under
-[Weighing point]- [Calib]- [Param]- [Test mode]
the following is displayed by calling the Test with the
key later on:
-
with [Absolute] the maximum load
-
with [Relative] the deviation from the test value
7.14.13
Saving the calibration
Quit calibration by pressing the
softkey.
You are prompted to confirm whether calibration should be closed without determining
the test value.
By pressing [Save] altered calibration data are saved.
The verification is displayed by "Saving calibration".
7 Commissioning
X3 Process Indicator PR 5410
EN-171
Minebea Intec