7.17.8.3
Saving parameters
7.17.9
Configuring digital outputs
Configure the required function for [Output 1] to [Output 3] by selecting a signal from the
list.
The output is set to the corresponding state.
Selection list for output functions
Function
SPM Bit
Description
no condition
---
No condition
actual diginp1
X00 = 0
digital input 1: not active
actual diginp2
X01 = 0
digital input 2: not active
actual diginp3
X02 = 0
digital input 3: not active
1.
Select and confirm the condition line of the appropriate parameter.
A selection window opens.
2.
Select and confirm the appropriate line (here: If input 1 changes from 0 to 1 [Input 1
on], a taring signal is triggered only, if the condition under [Condition] is met (limit 1
out = active).
3.
If applicable, select additional conditions for the other parameter and confirm.
Press the
softkey to exit the menu.
7 Commissioning
X3 Process Indicator PR 5410
EN-233
Minebea Intec
